5. When the new software has been activated, remote radios will re-register with the base station. The
remote radios software version can verified with ‘Network Status > Network Table’ on page 331.
6. When the base station restarts with the new software, rediscover the nodes (see ‘Discover Nodes’ on
page 276).
7. Check that all remote radios are now running on the new software (see ‘Network Status > Network
Table’ on page 331).
Note: The following steps will only be necessary if for some reason steps 1-7 did not operate correctly
or if software activation is attempted before the distribution process ends or the remote radio was off
during steps 1-7 and turns on later. Thus, the following steps will most likely not be required.
8. If step 7 shows that not all remote radios are running the latest software version, restore the base
station to the previous software version (see ‘Software > Manager’ on page 297).
9. Attempt to re-establish connectivity to the remote radios that have failed to upgrade by navigating to
and remotely managing the remote radios individually.
10. Navigate to the remote radio history log and review the logs to determine the reason for the failure to
activate the new software version.
11. Take appropriate actions to address the reported issue. If connectivity restores with the failed remotes,
repeat steps 2-7 if required.
To Next Page
Loading...
