Aprisa SR+ User Manual 1.11.1
Compliance United States of America FCC
The Aprisa SR+ radio is designed to comply with the Federal Communications Commission (FCC)
specifications as follows:
47CFR part 24, part 27, part 90 and part 101 Private Land
Mobile Radio Services
47CFR part 15 Radio Frequency Devices
(note 1)
, EN 301
489-1 and 5
ETS 300 019 Class 3.4, IEEE 1613 Class 2
IEC 61850-3, Ingress Protection IP51
UL / EN 60950-1:2006
Class 1 division 2 for hazardous locations
12.5 kHz, 15 kHz,
25 kHz, 50 kHz
757-758 MHz and
787-788 MHz
(note 3)
12.5 kHz, 25 kHz,
50 kHz, 100 kHz
12.5 kHz, 25 kHz,
50 kHz, 100 kHz
Part 24 /
Part 90 /
Part 101
12.5 kHz, 25 kHz,
50 kHz, 100 kHz
Part 24 /
Part 90 /
Part 101
Note 1: This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required
to correct the interference at his own expense.
Note 2: The Frequency Band is not an indication of the exact frequencies approved by FCC.
Note 3: For 700 MHz FCC Part 27 compliance in the Upper A block, the following frequency range restrictions
apply:
757.01250 MHz to 757.98750 MHz
787.01250 MHz to 787.98750 MHz
757.01875 MHz to 757.98125 MHz
787.01875 MHz to 787.98125 MHz
757.03750 MHz to 757.96250 MHz
787.03750 MHz to 787.96250 MHz
757.07500 MHz to 757.92500 MHz
787.07500 MHz to 787.92500 MHz
To Next Page
Loading...
