Compliance Hazardous Locations Notice
This product is suitable for use in Class 1, Division 2, Groups A - D hazardous locations or non-hazardous
locations. A Nationally Recognized Testing Laboratory (NRTL) listed power supply is required to power the
equipment.
The following text is printed on the Aprisa SR+ fascia:
WARNING: EXPLOSION HAZARD - Do not connect or disconnect while circuits are live unless area is known to
be non-hazardous.
The following text is printed on the Aprisa SR+ where the end user is in Canada:
AVERTISSEMENT: RISQUE D'EXPLOSION - Ne pas brancher ou débrancher tant que le circuit est sous tension,
à moins qu'il ne s'agisse d'un emplacement non dangereux.
The USB service ports are not to be used unless the area is known to be non-hazardous.
Compliance IEEE 1613 class 2
Users requiring compliance to IEEE 1613 class 2 shall use screened cables and connectors to connect to the
serial ports.
Compliance IEC 61850-3
Users requiring compliance to IEC 61850-3 shall use screened cables and connectors to connect to the serial
ports.
Note that during certain supply voltage dips and interruptions, the alarm status may change while the unit
is recovering from such an event.
To Next Page
Loading...
