Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
Installation of sets in the M7xx range 05/2008 Page 4-31
4.8.4.4 To start as of R1.3
Recommendations
As of R1.3, the set's language (label display managed locally by the set) synchronizes
automatically with the system it is connected to (label display sent by the system in the country's
language).
Procedure
Once the set is connected, the screen of the M780 displays for a few seconds:
Then automatic display of the first calibration screen:
Press the cross center situated at the top left of the screen with your stylet.
Automatic display of the second calibration screen:
Press the cross center flashing at the bottom right of the screen with your stylet.
The set shifts to idle and displays the home screen; the set is ready for use.
Press the centre of the cross
located at the top left of the screen
with your stylet to (re)calibrate
your touch-sensitive screen.
Press the centre of the cross
located at the top left of the screen
with your stylet to (re)calibrate
your touch-sensitive screen.
To Next Page
Loading...
