Installation Manual for digital sets - IP sets - SIP sets AMT/PTD/TR/0001/3/7/EN
To install sets and cartridges in the i7XX range 05/2008 Page 5-19
5.3.4.5 Ethernet configuration parameters
Attention :This procedure concerns the i740 sets with a software release lower than R5.3c. From
R5.3c, the parameters of configuration are identical to those of the i740N set.
Nota : By default, the set is set to autonegotiation, and adapts to the relevant LAN and PC
configurations.
Attention :It is not possible to manually program the Ethernet port in the CISCO Remote supply
mode.
%DFNWRWKHILUVWRSWLRQ
&RQILUPDQGH[LWSURJUDPPLQJ
To Next Page
Loading...
