11
Making a call
Calling an internal party by name
If you do not know your internal party's number, you can access it by entering their name on
the alphanumeric keypad. With the set in standby mode:
1 - Press the key .
he screen prompts you to enter the beginning of the
name you are looking for.
2 - Select the required character by successively pressing
the corresponding key:
Example:
- pressing the key once displays the letter A,
- pressing the key twice displays the letter B,
- pressing the key three times displays the letter C.
To enter a letter that is located in another key:
- Press another key immediately to enter the next letter
based on the same principle.
To enter another letter that is located in the same key:
- Wait (3 seconds) for the cursor to flash at the next
position.
- If required, press the Erase key to erase the last
character selected.
3 - Press the Consult/Next key to display the first answer.
Note: if several answers exist, the Consult/Next key remains lit.
- Successively press the Consult/Next key until the
required name is displayed.
- Use the keys or to display the first name and
the number that is associated to this name.
To go back to the previous name:
- Press the Previous key.
To change the entry:
- Press the Correct key.
4 - Press the green key to call the party whose name is
displayed.
The set automatically calls the party.
The display shows the name of the internal party.
ABC...?
1 = space - !"%,./:?+<=>
2 = ABC2
3 = DEF3
4 = GHI4
5 = JKL5
6 = MNO6
7 = PQRS7
8 = TUV8
9 = WXYZ9
0 = 0
* = *
# = #
To Next Page
Loading...
