46
The "Do not disturb" function
Programming the "Do not disturb" function on a programmable
If this function is repetitive, you can store it on a programmable key.
1- Press the key .
2- Press a programmable key.
The indicator associated to this key flashes.
3- Enter the type code or *.
4 - Dial the sequence .
5- Press the key .
The indicator associated to the key goes off.
You want to enable the "Do not disturb" function:
- Press the programmed key.
An audible message and the display indicate that the
action has been validated.
The indicator associated to the programmed key lights
up.
You no longer receive any calls.
You want to disable the "Do not disturb" function:
- Press the programmed key.
An audible message and the display indicate that the
action has been validated.
The indicator associated to the programmed key goes off.
You receive calls again.
Enable the function:
Disable the function:
Do not disturb
Do not disturb
*Depending on the programming done by the system operator
To Next Page
Loading...
