Abarth 595 - Page 60

47
select the main menu setting you wish
to change;
press the + or – buttons (with single
presses) to select the new setting;
briefly press the MENU buttonto
store the new setting and to go back to
the same main menu option selected
previously.
Selecting an optionfrom the main
menu with a submenu:
briefly press the MENU buttonto
display the first submenu option;
press the + or –buttons (with single
presses) to scrollthrough all the
submenu items;
briefly press the MENU buttonto
select the displayed submenu option
and to open the relevant setup menu;
press the + or – buttons (with single
presses) to select the new setting for
this submenu option;
a short press on MENU button
will store the setting and then return to
the same submenu option that was first
selected.
Dimmer(Adjust
thedashboardand
instrumentpanel
lighting)
On some versions, the instrument
panel is provided with a light sensor
capable of detecting environmental
light conditions andadjusting the
brightness of the instruments
accordingly.
The brightness ofthe instrument panel
may therefore change while driving
following an event causing a switch
from “day” to “night” conditions (or vice
versa) in the passenger compartment
(e.g. in a tunnel, onavenues in
shadows, under flyovers, etc.).
It is possible to manually adjust the
instrument panel, control buttons and
automatic climate control lighting. The
night mode can only be adjusted with
the headlights on.If the headlights are
not on, it can be adjusted in day mode.
Proceed as followsto adjust the light
intensity:
press the MENUbuttonbriefly
to make the display flash the previously
stored level;
press the + or – button to adjust the
brightness level;
press the MENUbuttonbriefly to
return to the menuscreen or hold the
button down to return to the standard
screen without storing.
On some versions, during the daytime
and with dipped headlights on, the
instrument panel, control buttons and
automatic climate control displays are
set to maximum brightness.
Speedbeep(Speed
limit)
With this function it ispossible to set
the car speed limit(km/h or mph);
when this limit is exceeded the driver is
alerted.
To set the desiredspeed limit, proceed
as follows:
briefly press the MENU button:
the display will show the words "Speed
Beep";
press the + orbutton to select
speed limit activation (“On”) or
deactivation (“Off”);
if the function is enabled (On), press
the
+ or – button to select the required
speed limit and press the MENU button
to confirm.
NoteThe speed maybe set anywhere
between 30 and 200 km/h or 20 and
125 mph, depending on the previously
chosen unit, see the “Setting the unit
of measurement (Unit)” paragraph.
The setting will increase/decrease
by 5 units each time button
+ / – is
pressed. Hold down the
+ / – button
to automatically increase/decrease
the setting rapidly.Complete the
adjustment with single presses of the
button when youapproach the desired
value.
Press the MENUbutton
briefly to
return to the menuscreen or hold the