Abarth 595 - Page 61

KNOWING THE INSTRUMENT PANEL
48
button down to return to the standard
screen without storing.
To cancel the setting, proceed as
follows:
press the MENUbuttonbriefly to
make the display flash "On";
press the – button,"Off" will flash on
the display;
press the MENUbuttonbriefly to
return to the menuscreen or hold the
button down to return to the standard
screen without storing.
TripBactivation/data
This function may be used to activate
("On") or deactivate("Off") the Trip B
(partial trip) display.
For further information see the “Trip
computer” paragraph in this chapter.
Proceed as followsto switch the
function on/off:
press theMENU button briefly,
the display will flash"On" or "Off"
depending on theprevious setting;
press + or – buttonto select;
press the MENUbuttonbriefly to
return to the menuscreen or hold the
button down to return to the standard
screen without storing.
SetTime(Settingthe
clock)
Using this function, it is possible to
set the clock through two submenus:
"Time" and "Format".
To adjust, proceedas follows:
briefly press the MENUbutton:
the display will show the two submenus
“Time” and “Format”;
press the + or – button to move
between the twosubmenus;
once you have selected a submenu,
press the MENU
button briefly;
when you select the “Time”
submenu, pressing the MENU
button briefly the display shows the
"hours";
press the + or – button to adjust;
briefly pressing theMENUbutton
the “minutes” are displayed;
press the + or – button to adjust.
NoteThe setting will increase or
decrease by oneunit each time the
+
or
– button is pressed. Hold down the
button to increase/decrease the setting
rapidly and automatically. Complete the
adjustment with single presses of the
button when youapproach the desired
value.
When you select the “Format”
submenu, pressing the MENU
button briefly the mode is displayed;
press + or – to select “24h” or “12h”.
When you have made the adjustment,
press SAVE to return to the submenu
screen or hold thebutton down to
return to the mainmenu screen without
storing.
hold the MENU buttondown
again to return to the standard screen
or to the main menu according to
where you are in the menu.
Setdate(Settingthe
date)
This function may be used to update
the date (year/month/day).
To adjust, proceedas follows:
briefly press the MENUbutton:
“year” will be displayed;
press the + or – button to adjust;
briefly press the MENUbutton:
"month" is displayed;
press the + or – button to adjust;
briefly press the MENUbutton:
“day” is displayed;
press the + or – button to adjust;
NoteThe setting will increase or
decrease by oneunit each time the
+
or
– button is pressed. Hold down the
button to increase/decrease the setting
rapidly and automatically. Complete the
adjustment with single presses of the
button when youapproach the desired
value.
Press SAVE to return to the menu
screen or hold thebutton down to
return to the standard screen without
storing.