11
2.1 Introduction
The Operator level (Level 1) is the normal day-to-day mode of the COMMANDER 351. This section
describes the operator facilities available on each frame depending on the control template and
output type selected.
The template types detailed in this section are:
• Single loop controller
• Auto/Manual station
• Analog backup station
• Indicator/manual loader station
Note. Only the frames relevant to the selected template are displayed – see Section 4.
In addition, frames used to view the Control Efficiency Monitor and operate motorized valve and heat/
cool output types are also described.
2 OPERATOR LEVEL
Fig. 2.1 Power-up Displays
01.SL
C351
Model – C351, Basic Version
Template (see rear fold-out)
Software series
Software version
04
2001
To Next Page
Loading...
