ABB COMMANDER 351 - Level 6 - Basic Configuration

40
…4.2 Level 6 – Basic Configuration
Control Output Type
The appropriate relays, digital outputs and analog outputs are assigned
to the control output variables. The other hardware outputs are
provisionally assigned to alarm and retransmission functions but these
may be changed in the output assignment level – see Section 4.8.
Select the Output Type required – see also Fig. 4.2 overleaf and Rear
Fold-out/ Table B.
Continued…
AnLG
O.tYP
6.02
•1
6.02
…4 CONFIGURATION MODE
•1 Only output types 'nOnE' and 'AnLG' are applicable to indicator templates. Only output type 'AnLG' is
applicable to auto/manual station and analog backup templates.
•2 Analog Input 3 Type defaults to '11' – Resistance Feedback.
yalpsiDepyTtuptuO
EnOn
enoN
GLnA
)1oa=tuptuolortnoC(tuptuogolanA
YLr
)1YLR=tuptuolortnoC(tuptuoyaleR
GId
)1od=tuptuolortnoC(tuptuolatigiD
bFP
kcabdeefhtiwevlavdezirotoM
)2YLR=esolC,1YLR=nepO(
2•
dNb
kcabdeeftuohtiwevlavdezirotoM
)2YLR=esolC,1YLR=nepO(
rr.CH
yaler=2PO,yaler=1POhtiwlooc/taeH
dr.CH
tuptuolatigid=2PO,yaler=1POhtiwlooc/taeH
rd.CH
yaler=2PO,tuptuolatigid=1POhtiwlooc/taeH
rA.CH
yaler=2PO,golana=1POhtiwlooc/taeH
AA.CH
golana=2PO,golana=1POhtiwlooc/taeH