87
351.5
350.
50
RS232 Serial Port
B7 Two Delay Timers
• Programmable delay and duration (0 to 9999 seconds)
B8 Two Custom Linearizers
• 15 breakpoints per linearizer
• The source can be any analog signal
B9 Template Customization
Each template can be customized by changing the sources for various functions in the
COMMANDER 350. This allows maths blocks and custom linearizers to be added into the standard
template format.
The following sources can be programmed:
• process variable inputs
• set point inputs
• position feedback input
• input to ratio/bias block
• ratio inputs
• bias inputs
B10 Connecting the COMMANDER PC Configurator
APPENDIX B – COMMANDER CONFIGURATION EDITOR
Note. The COMMANDER 350
must be in Configuration Mode
(levels 6 to E) and Modbus serial
communications must be
disconnected when using the PC
Configurator.
Fig. B1 Connecting the COMMANDER PC Configurator
To Next Page
Loading...
