ABB COMMANDER 351 - Table of Contents

2
CONTENTS
Section Page
1 DISPLAYS AND FUNCTION KEYS ......... 3
1.1 Introduction ...................................... 3
1.2 Use of Function Keys ....................... 4
1.3 Secret-til-Lit Indicators ..................... 8
1.4 Character Set................................... 8
1.5 Error Messages ............................... 9
1.6 Processor Watchdog...................... 10
1.7 Loop Break Monitor ....................... 10
1.8 Glossary of Abbreviations .............. 10
2 OPERATOR LEVEL ................................ 11
2.1 Introduction .................................... 11
2.2 Single Loop Controller
(Templates 1 and 2) ....................... 12
2.3 Auto/Manual Station
(Templates 3 and 4) ....................... 14
2.4 Analog Backup
(Templates 5 and 6) ....................... 16
2.5 Indicator/Manual Loader Station
(Templates 7 and 8) ....................... 18
2.6 Heat/Cool Output Types ................. 19
2.7 Motorized Valve Output Types ........ 20
2.8 Auto-tune........................................ 21
2.9 Control Efficiency Monitor .............. 24
3 SET UP MODE ....................................... 27
3.1 Introduction .................................... 27
3.2 Level 2 – Tune ................................ 28
3.3 Level 3 – Set Points ....................... 32
3.4 Level 4 – Alarm Trip Points ............ 34
3.5 Level 5 – Valve Setup .................... 35
4 CONFIGURATION MODE ...................... 38
4.1 Introduction .................................... 38
4.2 Level 6 – Basic Configuration ........ 39
4.3 Level 7 – Analog Inputs ................. 43
4.4 Level 8 – Alarms ............................ 47
4.5 Level 9 – Set Point Configuration... 51
4.6 Level A – Control Configuration ..... 54
4.7 Level B – Operator Configuration .. 59
4.8 Level C – Output
Assignment Configuration.............. 61
4.9 Level D – Serial
Communications Configuration...... 67
4.10 Level E – Calibration ...................... 68
Section Page
5 INSTALLATION ...................................... 71
5.1 Mechanical Installation .................. 71
5.2 Electrical Installation ...................... 75
5.3 Relays ............................................ 78
5.4 Digital Output ................................. 78
5.5 Control or Retransmission
Analog Output ................................ 78
5.6 Motorized Valve
Connections ................................... 79
5.7 Input Connections .......................... 79
5.8 Output Connections ....................... 80
5.9 Power Supply Connections ............ 80
APPENDIX A – CONTROL TEMPLATES .... 81
A1 Single Loop Controller
(Templates 1 and 2) ....................... 81
A2 Auto/Manual Station and Analog
Backup Station............................... 82
A3 Indicator/Manual Loader Station
(Templates 7 and 8) ....................... 85
APPENDIX B – COMMANDER
CONFIGURATION EDITOR.......................... 86
B1 Introduction .................................... 86
B2 Analog Input Customization ........... 86
B3 Four Programmable Math Blocks .. 86
B4 Six Logic Equations ....................... 86
B5 Process Alarm Customization ....... 86
B6 Two Real Time Alarms ................... 86
B7 Two Delay Timers........................... 87
B8 Two Custom Linearizers ................ 87
B9 Template Customization ................ 87
B10 Connecting the COMMANDER PC
Configurator ................................... 87
SPECIFICATION........................................... 88
FRAMES INDEX ........................................... 92
INDEX ........................................................... 95