ETL600 1KHW001489-EN ABB Switzerland Ltd
HMI600 Alarm Text Explanation and corrective actions
(the latter in italics)
• Max Rx command
duration exceeded
A command has been received of duration longer than the
configured maximum (e.g.
Configuration / NSD600 /
Alarm TPE1 / Command outputs during link failure
)
s been exceeded. ha
• G4AI interfac
east one of the interfaces connected to G4AI caused
an alarm.
Check G4AI status for detailed information.
e alarm
At l
9.6.3.4. T s
HMI600 Alarm Text Explanation and corrective actions
(the latter in italics)
PE warning
• Active configuration
not stored to
EPROM
A test
when
Store he test
configuration timer, or reset the system, thereby
iting the test configuration.
configuration for TPE is active which will be lost
the associated test configuration timer runs out.
the configuration to EPROM, stopping t
overwr
• Local test loop
active
Local test lo
nd T
op is active for TPE (e.g.
Equipment / Tuning
esting / Test internal teleprotection
).
a
• Loop test failed
once or twice
The next cyclic loop test will be sent within 5 minutes
• Test signal
transmitted or
received
A TPE test signal has been transmitted or received.
• G4AI warning
A warn
Check
ing is present on at least one of the G4AI boards.
G4AI status for detailed information.
9.6.3.5. larms
HMI600 Alarm Text Expla
la
G4AI detail hardware a
nation and corrective actions
tter in italics) (the
• Tx single
component failure at
input 1-4
One c
input i
Replace the
omponent of the redundant circuitry of a command
s faulty.
faulty G4AI board.
Troubleshooting November 2005 9-27
To Next Page
Loading...
