Start-up 51
Control locations
ABB drives can receive control information from multiple sources
including digital inputs, analog inputs, the drive control panel and a
communication module (for e.g., the adapter module). ABB drives
allow the user to separately determine the source for each type of
control information (Start, Stop, Direction, Reference, Fault reset,
etc.).
To give complete control of the fieldbus master station over the
drive, select communication module as the source for this
information. The drive-specific parameter setting examples below
contain the drive control parameters needed in the examples. For
a complete parameter list, see the drives documentation.
To Next Page
Loading...
Need help?
General
