ABB FPBA-01 PROFIBUS DP - SAP 60 (SlaveDiag)

Communication protocol 123
SAP 60 (Slave_Diag)
This SAP gives diagnostic information on the slave station.
Diag_Data (Diagnostic Data)
Type: Octet String - Length: 6 (Standard)
+ 2 (Extended Diagnosis) (DP-V0 mode)
+ 5 (Extended Diagnosis) (DP-V1 mode)
Note: During initialization, the module only sends the standard part of the
message.
DU
Byte
Description
0 Station_Status_1
xxxxxxxx
Diag.Station_Non_Existent
(Set by Master, reset by Slave)
Slave not found
Diag.Stagion_Not_Ready
(Set by Slave) Slave not ready for
data exchange
Diag.Cfg_Fault (Set by Slave)
Received configuration data does
not match original config. data
Diag.Ext_Diag (Set by Slave)
Diagnostic entry present in slave-
specific diagnostic area
Diag.Not_Supported (Set by
Slave) Service not supported by
slave
Diag.Invalid_Slave_Response
(Set by Master, reset by Slave)
Invalid response by slave
Diag.Prm_Fault (Set by Slave)
Invalid parameter or parameter
value
Diag.Master_Lock
(Set by Master, reset by Slave)
Slave is parameterized by
another master
MSB LSB