ABB IRB 6620 - Page 56

NoteAction
CAUTION
Do not try to jog the robot to the exact
position (max distance 1mm).
Jog the robot into a position as near above
as possible to the recommended transport
position for the specific robot, as specified
in section Transport position with a transport
support on page 51.
2
See attachment point for the specific ro-
bot in the section Transport position with
a transport support on page 51
Use the brake release for axis 3 to reach the
final resting position on the transport support,
see the section Manually releasing the brakes
on page 79.
3
CAUTION
Do not attempt to tighten any attachment
screws without first releasing the brakes.
This can seriously damage the robot.
Tighten all the attachment screws, (A) and
(B), in the figure with the brake release for
axis 3 still activated starting with the lower
attachment screw.
4
Use the brake release for axis 5 and 6 to
reach the final resting position for the tool,
see the section Manually releasing the brakes
on page 79
5
56 Product manual - IRB 6620
3HAC027151-001 Revision: T
© Copyright 2006-2018 ABB. All rights reserved.
2 Installation and commissioning
2.3 Securing the robot with a transport support
Continued