REX610
!
Edit group: ↕+_2
Active group=1
A
GUID-F4032493-0788-4A2E-8191-DC577EE2BB5F V1 EN-US
Figure 40: Selecting a setting group
3.
To browse the settings, scroll the list with and and to select a setting
press .
4.
To browse different function blocks, scroll the list with and and to
select a function block press . To move back to the list, press .
The function block list is shown in the content area of the display. On the left
in the header, you see the current setting group, and on the right the menu
path.
5.
To browse the parameters, scroll the list with and and to select a
parameter, press .
The setting group values are indicated with #.
SG1: PHIPTOC1
Num of start phases
=1 out of 3
Start value
=1. 00 xIn #
A
!
GUID-EC5B697D-516D-48B7-92C2-54F4F69FF9A3 V1 EN-US
Figure 41: Setting group parameter
6.
To select a setting group value, press and to edit the value press .
*
[1]=1. 00 xIn
[2]=1. 00 xIn
[3]=1. 00 xIn
[4]=1. 00 xIn
A!
SG1: Start value
GUID-A8BD9462-8169-4C3E-B509-22483102CF7B V1 EN-US
Figure 42: Selecting the setting group value
Only values within the selected setting group can be changed.
7.
Press or to change the value and to confirm the selection.
2NGA000823 A Section 6
Operating procedures
REX610 53
Operation Manual
To Next Page
Loading...
