ABB REX610 - Defining Serial Port Settings; Setting Communication Protocol Parameters; Connecting Jumper Connectors

8.4.2.5 Setting communication protocol parameters
1. Select Main menu/Configuration/Communication/<protocol>.
2. Change the protocol specific settings.
Possible settings to be changed are, for example, the selected communication
port, address and link mode.
8.4.2.6 Connecting jumper connectors
See the technical manual for details on jumper connectors.
8.4.3 Setting local HMI
8.4.3.1 Changing local HMI language
1.
Select Main menu/Language and press
.
2.
Change the language using or .
3.
Press to confirm the selection.
4. Commit the changes.
Language
Language selection
=English (us, iec)
A
GUID-268C3E9F-3E32-436D-B232-353CF668968F V1 EN-US
Figure 51: Changing the local HMI language
To change the language using a shortcut, press
and
simultaneously anywhere in the menu.
8.4.3.2 Adjusting display contrast
Adjust the display contrast anywhere in the menu structure to obtain optimal
readability.
•
To increase the contrast, press simultaneously and .
•
To decrease the contrast, press simultaneously and .
2NGA000823 A Section 8
Commissioning
REX610 75
Operation Manual