ABB REX610 - Activating Programmable LEDs; Setting Autoscroll Delay

*
[1]=
↦
+_ _ _ _ 20 ms
[2]=20 ms
[3]=20 ms
[4]=20 ms
A!
SG1: Operate delay ...
GUID-7EC94852-A954-4A02-91DB-73BAE78A5C7E V1 EN-US
Figure 43: Editing the setting group value
The active setting group is indicated with an asterisk * .
Switching the Operation parameter of a function block on or off
restarts all control and protection functions.
6.4.2 Activating programmable LEDs
1. Select Main menu/Configuration/Programmable LEDs.
2.
Select a programmable LED with or .
3.
Press
to enter the selection and to change the programmable LED
mode.
4.
Change the mode with or and press to confirm the selection.
See the technical manual for details on LED configuration.
6.4.3 Setting autoscroll delay
Autoscroll delay parameter sets the delay of scrolling down measurements view if
it is set as default view and the user is logged out. Autoscroll is active if the delay
value is not zero.
1.
Select Main menu/Configuration/ HMI/Autoscroll delay and press
.
2.
Select delay time with or .
3.
Press to confirm the selection.
Section 6 2NGA000823 A
Operating procedures
54 REX610
Operation Manual