ABB REX610 - Warning Indications and Codes; Correction Procedures - Software Reboot

Warning indication Warning category Additional information
Report cont. Error
25
1)
IEC report error
SCL config error 27 Error in SCL configuration file or the
file is missing
Logic warning 28 Too many connections in the
configuration
SMT connect error 29 Error in SMT connections
GOOSE input warning
30
1)
Error in GOOSE connections
ACT Config. mismatch 37 Configuration mismatch
SDcard mount Warn 156 SD card mount error
PSU.data.invalid
160
1)
PSU traceability warning
DIO.data.invalid
161
1)
DIO traceability warning
AIU.data.invalid
162
1)
AIU traceability warning
AIC.data.invalid
163
1)
AIC traceability warning
HMI.data.invalid
164
1)
HMI traceability warning
LHMI keyscan error
169
1)
Keyscan error
GOOSE receive error 170 Error in GOOSE message receiving
GOOSE publish error
171
1)
Error in GOOSE publish
SDcard memory full 172 SD card memory is full
Device Cert. Expired 173 Device certificate expired
SDcard error 174 Error in SD card
SNTP error 175 Error in the SNTP module
Internal voltage error
176
1)
Voltage error detected
Inter. humidity sensor error 177 Error in internal humidity sensor
Inter. temp. sensor error 178 Error in internal temperature sensor
Access Errx 179 Setting write failure
Config. not available 181 Error in ACT connections/ACT
Configuration not available
SCL validation warning 182 Failure in SCL file validation
MMS report warning
183
1)
MMS report warning
MMS service warning
184
1)
MMS service warning
1) Used for software simulation
7.3 Correction procedures
7.3.1 Rebooting the software
1.
Select Main menu/Configuration/General/Software reset and press
.
2.
Change the value with or and press .
2NGA000823 A Section 7
Troubleshooting
REX610 63
Operation Manual