ABB S800 I/O - Page 169

Appendix B Dynamic Data DP820 Dynamic values
3BSE027630-600 B 169
r_co# Reset coincidence
DO# Activate DO
LED# Activate used LED
pcsy# Sync. (i.e. reset) of pulse counter
Sync condition# Synchronization condition 0 = Synchronization inhibit
1 = Sync. if pcsy=1
2 = Sync. if count.dir=up and input
ST=active
3 = Sync. if count.dir=down and
input ST=active
4 = Sync. if count.dir=up and input
DI=pos. edge
5 = Sync. if count.dir=down and
input DI=pos. edge
6 = Sync. if count.dir=up and input
DI=neg. edge
7 = Sync. if count.dir=down and
input DI=neg. edge
8 = Sync. if count.dir=up and input
ST=active and DI=pos. edge
9 = Sync. if count.dir=down and
input ST=active and DI=pos.
edge
10 =Sync. if count.dir=up and input
ST=active and DI=neg. edge
11 = Sync. if count.dir=down and
input ST=active and DI=neg.
edge
12 =Sync. if coincidence on "own"
channel
13 =Sync. if coincidence on "other"
channel
14 and 15 = Not used
Abbreviation Name Values