Section 3 Run-time Operation CI801
3BSE027630-600 B 51
• Power supervision of opto extension
Mark the check box if the voltage supply to the cluster shall be supervised.
Only if redundant power supply.
• Extended HART mode
Normal mode shall always be used if HART data is < 56 bytes. Mark the check
box if the HART data is
> 56 bytes but < 215 bytes. If Extended HART mode is
chosen less I/O modules can be used. See S800 I/O Manuals for more details.
• HCIR Enable
Hot Configuration In Run active
• HCIR Factor
Hot Configuration In Run Factor
• HCIR Watchdog
Hot configuration In Run Worst Case Bus Cycle Base
Figure 17. CI801 - Configuration for AC800F
To Next Page
Loading...
