• This device may not cause interference.
• This device must accept any interference, including interference that may cause
undesired operation of the device.
RF exposure statement
This equipment complies with IC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator and your body.
3.6 General safety instructions
• This document, the related documents and the warnings included do not
replace your responsibility to use your common sense when you do work on the
EVSE.
• Only do the procedures that the related documents show and that you are
qualified for.
• Obey the local rules and the instructions in this manual. If the local rules
contradict the instructions in this manual, the local rules will apply.
If and to the extent permitted by law, in case of inconsistency or contradiction,
between any requirements or procedure contained in this document and any
such local rules, obey the stricter between the requirements and procedures
specified in this document and the local rules.
3.7 Safety instructions for use
• In these situations, do not use the EVSE and immediately contact the
manufacturer:
• An enclosure has damage.
• An EV charge cable or connector has damage.
• Lightning struck the EVSE.
• There was an accident or a fire at or near the EVSE.
• Water has entered the EVSE.
3.8 Safety instructions during cleaning or maintenance
Preliminary requirements
•
• Keep unauthorized personnel at a safe distance during cleaning or maintenance.
• If for cleaning or maintenance it is necessary to remove safety devices,
immediately install the safety devices after the work.
• Put on the correct personal protective equipment. Refer to section 3.3.
Safety
BCM.V3Y00.0-EN | 002 31
To Next Page
Loading...
