ABB Terra AC - Wrap the EV Charge Cable Around the Enclosure

1. Select one of the two ways to end the charge session.
• Wait until the charge session is completed.
• The ChargerSync app shows that the charge session is completed
• The charging LED is on.
• If your EVSE has a display, the display shows that the charge session is
completed.
When the charge session is completed, the EVSE disconnects the power
supply automatically.
• Authorize the ending of the use of the EVSE with your RFID card or the
ChargerSync app. The authorization of the disconnection to the EV starts.
2. Disconnect the EV charge cable from the socket of the EVSE.
3. Disconnect the EV charge cable from the connector on the EV.
4.7 Wrap the EV charge cable around the enclosure
1. Wrap the EV charge cable around the
enclosure.
Operation
BCM.V3Y00.0-EN | 002 37