ABB Terra AC - Start a charge session

4.4 Start a charge session
4.4.1 EVSE with an EV charge cable
Caution: During the charge session, do not disconnect the EV charge
cable from the connection on the EV. There is a risk of damage of the
connector of the EV.
Note: The LEDs show the status of the charge session.
1. Take the EV charge cable from the enclosure.
2. Use your RFID card or ChargerSync app to authorize the use of the EVSE.
The authorization of the connection to the EV starts.
3. Connect the EV charge cable to connector of the EV.
The EVSE charges the EV.
4.4.2 EVSE with a socket
Caution: During the charge session, do not disconnect the EV charge
cable. There is a risk of damage of the socket of the EVSE or the
connector of the EV.
Note: The LEDs show the status of the charge session.
1. Connect your EV charge cable to the connection on your EV.
2. Use your RFID card or ChargerSync app to authorize for use of the EVSE.
The authorization of the connection to the EV starts.
3. Connect the EV charge cable to the socket of the EVSE.
The EVSE charges the EV.
4.5 Wake up the EV when it is unavailable
4.5.1 Wake up the EV (EVSE without display)
Preliminary requirements
1. The
ChargerSync app shows 'waiting for EV'.
Procedure
1. Disconnect the EV charge cable from the EV.
2. Connect the EV charge cable to the EV again.
Operation
BCM.V3Y00.0-EN | 002 35