Abus NVR10030P - DDNS Configuration

43
DDNS
The DDNS function is used to update host names and DNS entries.
If you want to use the ABUS server for remote access, proceed as follows:
1) In order to be able to use the ABUS DDNS function, you must first set up a
free account at http://www.abus-server.com. Please read the FAQs on this
topic on the website.
2) Please make sure that you set up your ABUS devices on the ABUS server
correctly using the relevant MAC address before activating the ABUS server
DDNS function.
3) Activate/deactivate the DDNS function
4) Enter the user name and password of your ABUS server account
5) Click on “Save”.
IPv4 default
gateway
Enter the IP address of the gateway on the network during
manual assignment, normally this is the IP address of the
router
MAC address
Hardware address of the integrated network card
MTU(Bytes)
Describes the maximum protocol packet size.
Preferred DNS
server
IP address of the domain name server, usually the IP
address of the router
Alternative DNS
server
Alternative IP address of DNS server
Obtain DNS server
address
automatically
Automatically obtains the correct DNS server address from
the DHCP server
Enable
Here you can enable DDNS synchronisation
DDNS type
Here you can select the DDNS service provider
Server address
Enter the IP address or host name of the DDNS provider here
Device domain
name
If necessary, enter the sub domain of the device here
Status
Display of the DDNS status
User name
Enter the user name of your DDNS account here
Password
Enter the password for your DDNS account here