Abus NVR10030P - Email Alert Configuration

46
Advanced settings – Email
In the event of an alarm, the device can send a message by email. Enter the email
configuration here.
Server
authentication
Tick the box when authentication on the server is required
User name
Enter the user name of your email account here
Password
Enter the password of your email account here
Sender
Enter the sender name here
Sender’s address
Enter the email address linked to the email account here
Select recipients
Here you can select up to three different recipients and then
enter their email addresses
Recipient
Enter the name of the recipient here
Recipient’s address
Enter the recipient’s email address here
Enable attached
picture
Tick the box if camera recordings should also be sent with the
email as photo files
Interval
Select a trigger time of between two and five seconds. The
pictures will only be sent if motion is detected during the time
frame defined.
SMTP server
Enter the SMTP server address of the email provider here
SMTP port
Enter the SMTP port of the email provider here.
Enable SSL/TLS
Tick the box to enable email encryption