28
DRIVE STATUS TABLE
DISPLAY
DISPLAYDISPLAY
DISPLAY DESCRIPTION
DESCRIPTIONDESCRIPTION
DESCRIPTION
STOP Drive is in STOP mode - No output to the motor.
RUN Drive is in RUN mode and is within +
3 Hz of the speed setpoint.
FAULT Drive has shut down due to a FAULT condition. If the fault
condition has passed, pressing the STOP key will clear the fault
and return the drive to the STOP mode.
LOCK Drive is in FAULT LOCKOUT after five unsuccessful restart
attempts.
BRAKE DC BRAKE is energized.
LIMIT Drive is in CURRENT LIMIT due to an overloaded motor, or
ACCEL is set too fast.
F DEC Drive is in DECEL FREEZE because DECEL rate is too fast.
The following table shows the possible DRIVE STATUS indications that can
appear on the drive display:
To Next Page
Loading...
