Need help?Do you have a question about the AC Tech MC1000 series and is the answer not in the manual?
Warranty details for MC Series AC motor control for 18 months.
Input/output ratings for M1100 Series drives.
Input/output ratings for M1200 Series drives.
Input/output ratings for M1400 Series drives.
Input/output ratings for M1500 Series drives.
Discusses mounting surface, vertical position, spacing, and cooling.
Input voltage must match nameplate, with tolerance limits.
Requirements for circuit breakers, fuses, and disconnect switches.
Details input voltage ratings and operating ranges for series.
Wire sizing, fusing, disconnects, conduit, voltage drop.
Instructions for wiring single and three-phase inputs.
Power wiring diagrams and essential installation notes.
Procedure to verify correct motor rotation direction.
Use STOP key to reset faults.
Shows display configurations in FAULT mode (Fault message, Speed, Load, Voltage).
Details remote mode selection and start/stop control methods.
Methods for two-wire start/stop control.
Setup for forward/reverse rotation with one or two run contacts.
Alternate method for two-wire start/stop control.
Setup for forward/reverse with one run contact.
Methods for three-wire start/stop control.
Setup for forward/reverse with one start contact.
Diagram of terminal strip with function descriptions.
Wiring diagram for two-wire start/stop control.
How to enter PROGRAM mode and navigate parameters.
Table listing parameters, ranges, and defaults.
Continued table of parameters, ranges, and defaults.
Continued table of parameters, ranges, and defaults.
Parameter for calibrating drive to input voltage (AUTO, HIGH, LOW).
Sets acceleration rate from 0 Hz to BASE FREQUENCY.
Sets deceleration rate from BASE FREQUENCY to 0 Hz.
Defines the lower limit of the drive's speed range.
Defines the upper limit of the drive's speed range.
Sets maximum output current and torque capability.
Protects motor from overheating due to excessive current.
Sets frequency where drive outputs full voltage to motor.
Selects starting method (NORMAL, POWER UP, AUTO RE-, RE-BRAKE).
Selects motor stop mode (COAST or RAMP).
Selects start/stop command source (LOCAL, REMOTE, BOTH).
Limits access to parameters with a password.
Resets parameters to factory default settings.
Table of fault messages and possible causes.
Table of fault messages and possible causes (continued).
Step-by-step guide for installing DB/Relay boards.
To Next Page
General
