73
70 FAULT HISTORY
The FAULT HISTORY stores the previous eight fault conditions that caused the
drive to trip. The information stored here is view-only, it cannot be altered. The
FAULT HISTORY can be used to determine if there is a pattern, or trend, to the
faults, which may indicate a problem in the system. Refer to Section 19.0 -
TROUBLESHOOTING for more information on faults.
The FAULT HISTORY indicates the number of the fault (number 1 is the most
recent fault), the fault message, and the status of the drive at the time of the fault.
An example is shown below:
In the example above, the third fault log is being viewed, which is an OVERLOAD
fault that occurred while the drive was in a RUN state.
3 OVERLOAD RUN
DRIVE
STATUS
FAULT
NUMBER
FAULT
MESSAGE
To Next Page
Loading...
