Chapter 3, Preparing the devices
3-2
Accu-Chek Smart Pix user's manual
In some cases, these devices require different preparations
in order to be able to transfer data to the Accu-Chek Smart
Pix system. On the following pages, you will find the
procedure for each device to analyse stored data
successfully. You or the user can also find this information in
the manuals for the meters, insulin pumps and Accu-Chek
Pocket Compass software.
Always prepare only one device at a time for data
transfer. Otherwise, data transfer might be interfered
with by simultaneous communication attempts. Also
avoid possible interference by infrared ports of other
devices such as laptops or mobile phones.
Avoid direct extraneous light (e.g. sunlight) because it
may interfere with data transfer.
If you want to analyse combined data from more than
one device (e.g. meter and insulin pump or several
meters), do
not
click on the
Erase Report
button
between the data transfers. Start data transfer from
further devices by clicking the
Read Device
button
after each transfer is completed.
If you want to analyse insulin pump data together
with meter data, the devices must be
synchronized
,
i.e. all devices involved should have the same date
and time settings. Deviations of ± 5 minutes
maximum are tolerated; if the deviation is greater, no
combined reports are created.
To Next Page
Loading...
Need help?
General