Acer Aspire 8951G - Power Board Removal; Power Board Installation

3-32 Machine Maintenance Procedures
Power Board Removal 0
Prerequisite:
Keyboard Assembly Removal
NOTE:
NOTE:
Power board and RJ45 connector are located on same board.
1. Locate power board (C) on lower cover. (Figure 3-29)
2. Disconnect power board FFC (A) from mainboard connector (B). (Figure 3-31)
Figure 3-34. LAN Board
3. Remove screw (D) from upper cover.
4. Lift and remove power board (C) from upper cover slot and guidepins (E).
Power Board Installation 0
1. Align and install power board (C) into upper cover slot and guidepins (E). (Figure 3-32)
2. Install and secure screw (D) to upper cover.
3. Connect power board FFC (A) to mainboard connector (B).
ID Size Quantity Screw Type
D M2.5x6.5 1
D
E
A
B
E
C