5-6 Jumper and Connector Locations
Clearing Password and BIOS Recovery 0
This section provides users with the SOP (standard operating procedure) for clearing the
BIOS password and recovering the BIOS for the Aspire 8951G.
Clearing Password 0
The following procedure is only for clearing BIOS Password (Supervisor Password and
User Password).
Clearing BIOS Password 0
If a BIOS password (Supervisor Password and/or User Password) is set, the BIOS will prompt
for the password at system POST or upon entering the BIOS setup menu. Clear the password
check with the following procedure:
1. Remove AC adapter.
2. Locate the CMOS jumper point (A). (Figure 5-3)
Figure 5-3. CMOS Jumper Overview
3. Short two points of jumpers (A).)
4. Plug in AC adapter.
5. Press Power button until BIOS POST is finished.
6. Remove conductivity tool from RCT_RST point.
Item Description
Clear CMOS Jumper
To Next Page
Loading...
