Acer Aspire 8951G - Miscellaneous Tools; Using Boot Sequence Selector

System Utilities 2-23
Miscellaneous Tools 0
Using Boot Sequence Selector 0
The Boot Sequence Selector allows the boot order to be changed without accessing the BIOS
Setup Utility. To use the Boot Sequence Selector, perform the following steps:
1. Boot to DOS.
2. At a DOS prompt, enter bs <#> and a boot sequence ID number. A boot sequence ID is a
digit from 1 to 4.
Figure 2-27. Boot Sequence Selector
NOTE:
NOTE:
Enter bs <2> at the command prompt to change the boot sequence to HDD | CD ROM
| LAN | Floppy.
d:\BOOTSEQ>bs
***
Boot Sequence Selecter Version 0.03
***
Create by Rockwell Chuang 10/01/2005.
Usage:
BS [ 1 2 3 4 ]
BS 1 : [ Floppy ] => [HardDisk] => [ CD-ROM ] => [ LAN ]
BS 2 : [HardDisk] => [ CD-ROM ] => [ LAN ] => [ Floppy ]
BS 3 : [ CD-ROM ] => [HardDisk] => [ LAN ] => [ Floppy ]
BS 4 : [ LAN ] => [ Floppy ] => [HardDisk] => [ CD-ROM ]
d:\BOOTSEQ>