3-48 Machine Maintenance Procedures
Mainboard Installation 0
Use caution when installing mainboard. Forced installation may damage left side
connectors.
Make sure all cables are clear from mainboard during installation.
1. Install mainboard by sliding side (P) at a slight angle into slots on lower cover.
(Figure 3-52)
2. Install side (N) of mainboard until bottom speaker module (Q) and guidepin are aligned.
3. Install and secure screws (M) to upper cover. (Figure 3-51)
4. Connect bottom speaker cable (K) to mainboard connector (L). (Figure 3-50)
5. Connect upper speaker cable (H) to mainboard connector (J).
6. Connect USB board FFC (F) to mainboard connector (G).
7. Connect Bluetooth cable (D) from mainboard connector (E)
8. Install DT cable (A) to guide (C).
9. Connect DT cable (A) to mainboard connector (B).
10. Install upper cover.
ID Size Quantity Screw Type
M M2.5x4.0 5
To Next Page
Loading...
