X1161/X1261/X1161A/X1161N/X110/H5360 Condential
5-4
5-3 USB Driver Upgrade
Procedure (for X1161/
X1161A/X1161N/X110)
1. Set-up
- Hold on "power" button and plug in the
power cord.
- The power LED lights red and blue
simultaneously after 5 seconds, then
loosen "power" button.
- Connect projector with PC by USB
cable.
2. Execute Program
(1) "Found New Hardware Wiszard" picture
will appear on the screen.
(2) Select "Install the software automatically
(Recommended)".
(3) Click "Next".
(4) Searching picture, please wait for
several seconds.
(5) Click "Finish", then the USB driver has
been installed successfully.
Note: - If you have installed the USB driver, there
is no need to perform this action.
(2)
(3)
(1)
(5)
To Next Page
Loading...
