Any status or alarm messages (either WARNING or SOFT FAULT) appear on yellow background and are
flashing frequently in order to attract the operator's attention (see Figure 4-1 | Appearance of an alarm
message). In cases where more than one messages need to be displayed at the same time, they are being
automatically toggled every few seconds.
The WARNING messages appear only temporarily (for about three seconds), afterwards the indication is
restored automatically (see Section 4.3.a) First protection level - WARNING).
The SOFT FAULT messages appear in the same field but they remain on the screen until the AUTO OPERATE
time is elapsed (see Section 4.1.c) AUTO OPERATE user settings) or until the operator pushes any button.
k) Call sign area
Please, see Figure 3-2 | Basic screen, Pos. (k).
As its name suggests this field can be used to display the User's callsign, however, any custom text can be
set in the USER PREFERENCES menu.
3.5. Control System - Buttons and Menus
1) The OPERATE/STANDBY button is used for manual (local) control.
Please, see Figure 3-2 | Basic screen, Pos. 1.
The button OPERATE/STANDBY switches over the amplifier between OPERATE and STANDBY modes, and
serves as an indicator of the current state;
2) The ten band-selection buttons are used for direct manual (local) control.
Please, see Figure 3-2 | Basic screen, Pos. 2.
These ten buttons are used to select the desired band and are labeled in meters. Currently selected band is
highlighted and upon selecting one, the FREQUENCY indicator (see Figure 3-2 | Basic screen, Pos. (a)) changes
its value to reflect the change.
3) The MENU button provides access to the amplifier's settings and service functions.
Please, see Figure 3-2 | Basic screen, Pos. 3.
For more details on the control system and use of the menus see Section 5 MENUS - SETTINGS AND SERVICE
FUNCTIONS.
To Next Page
Loading...
