20 80-0180-307, Rev A
• LED Indicator. All 3 LED’s can be disabled in User Mode by the
Master or Supervisor code (PCC32), but will remain enabled in
programming mode. Yellow indicates programming mode.
Green indicates successful entry. Red indicates input error. The
LED’s will also flash to indicate various conditions.
• Variable Re-lock time. The duration that the eForce 150
remains unlocked can be adjusted (PCC 44) from 1 to 9
seconds. Default is 4 seconds.
Programming the User Codes
The eForce 150 can support 152 individual user codes. Each code is
assigned a code location (1–152) in addition to a user name and the
code’s programmed digits. Program Command Code 51 is used for
programming Master, Emergency, Supervisor, Lockout, Passage,
Normal, and One Time User codes. The Master code is always code
location number 1 and can be used to operate and program the eForce
150. A record log in included in this document to assign and log all
codes before proceeding on to programming. The log should be stored
in a secure location.
Master Code
1. PERFORM the following to program the Master Code (Location 1).
NOTE: Yellow LED will blink continuously during programming.
a. PRESS and HOLD # for approximately 5 seconds, and
RELEASE when the yellow LED blinks.
NOTE: After Step b, there will be green LED flash and 2 short
tones.
b. ENTER 1234#.
NOTE: After Step c, there will be green LED flash and 2 short
tones.
c. ENTER 51#
NOTE: After Step d, there will be green LED flash and 2 short
tones.
d. ENTER 1#
To Next Page
Loading...
