ADAMS RITE 3090 - Reset All Features to Default Values

28 80-0180-307, Rev A
NOTE: Completing the following programming section does not include
resetting User Codes.
Reset All Features to Default Values
1. PERFORM the following to reset all features to factory default
values.
NOTE: Yellow LED will blink continuously during programming.
a. PRESS and HOLD # for approximately 5 seconds, and
RELEASE when the yellow LED blinks.
NOTE: After Step b, there will be green LED flash and 2 short
tones.
b. ENTER Master or Supervisor Code and then #.
NOTE: After Step c, there will be green LED flash and 2 short
tones.
c. ENTER 72#.
NOTE: After Step d, there will be green LED flash and 2 short
tones to indicate successful programming.
d. RE-ENTER 72#.
2. PRESS # within 2 seconds to stay in programming mode.
Set Audible Keypad Feedback
1. PERFORM the following to set audible keypad feedback.
NOTE: Yellow LED will blink continuously during programming.
a. PRESS and HOLD # for approximately 5 seconds, and
RELEASE when the yellow LED blinks.
NOTE: After Step b, there will be green LED flash and 2 short
tones.
b. ENTER Master or Supervisor Code and then #.
NOTE: After Step c, there will be green LED flash and 2 short
tones.
c. ENTER 31#.
NOTE: After Step d, there will be green LED flash and 2 short
tones to indicate successful programming.
d. ENTER either 1# (for enable) or
0# (for disable).
2. PRESS # within 2 seconds to stay in programming mode.