ADAMS RITE 3090 - Delete All User Codes; Delete Supervisor, Lockout, Passage, or a Single Normal User Code

26 80-0180-307, Rev A
NOTE: After Step f, there will be green LED flash and 2 short
tones to indicate successful Supervisor Code
programming.
f. RE-ENTER desired Code and then #.
2. PRESS # within 2 seconds to stay in programming mode.
Programming Features and Options
NOTE: Completing the following programming section returns the
eForce 150 to factory settings.
Delete All User Codes
1. PERFORM the following to delete All User Codes.
NOTE: Yellow LED will blink continuously during programming.
a. PRESS and HOLD # for approximately 5 seconds, and
RELEASE when the yellow LED blinks.
NOTE 1: After Step b, there will be green LED flash and 2 short
tones.
NOTE 2: Entering the Supervisor Code will delete User Codes 6–
150 only.
b. ENTER Master or Supervisor Code and then #.
NOTE: After Step c, there will be green LED flash and 2 short
tones.
c. ENTER 60#.
NOTE: After Step d, there will be green LED flash and 2 short
tones to indicate successful programming, deletion of all
User Codes, and return to factory default settings.
d. RE-ENTER 60#.
Delete Supervisor, Lockout, Passage, or a Single Normal
User Code
1. PERFORM the following to delete Supervisor, Lockout, Passage, or
a Single Normal User Code.
NOTE: Yellow LED will blink continuously during programming.
a. PRESS and HOLD # for approximately 5 seconds, and
RELEASE when the yellow LED blinks.