22 80-0180-307, Rev A
NOTE: After Step c, there will be green LED flash and 2 short
tones.
c. ENTER 51#
NOTE: After Step d, there will be green LED flash and 2 short
tones.
d. ENTER 2#
NOTE 1: Emergency Code must be 4–7 digits.
NOTE 2: After Step e, there will be green LED flash and 2 short
tones.
e. ENTER new Emergency Code and then #.
NOTE 1: After Step f, there will be green LED flash and 2 short
tones to indicate successful Emergency Code
programming.
NOTE 2: Emergency Code defaults to a 10-second unlock time
[PCC 46#].
f. RE-ENTER new Emergency Code and then #.
2. PRESS # within 2 seconds to stay in programming mode, and then
ENTER 51# to continue programming.
Supervisor Code
1. PERFORM the following to program the Supervisor Code (Location
3).
NOTE: Yellow LED will blink continuously during programming.
a. PRESS and HOLD # for approximately 5 seconds, and
RELEASE when the yellow LED blinks.
NOTE: After Step b, there will be green LED flash and 2 short
tones.
b. ENTER Master Code and then #.
NOTE: After Step c, there will be green LED flash and 2 short
tones.
c. ENTER 51#
NOTE: After Step d, there will be green LED flash and 2 short
tones.
d. ENTER 3#
To Next Page
Loading...
