ADAMS RITE 3090 - Delete a Block of Normal User Codes

27 80-0180-307, Rev A
NOTE: After Step b, there will be green LED flash and 2 short
tones.
b. ENTER Master Code and then #.
NOTE: After Step c, there will be green LED flash and 2 short
tones.
c. ENTER 61#.
NOTE: After Step d, there will be green LED flash and 2 short
tones to indicate successful programming.
d. ENTER desired code location and then #.
Delete a Block of Normal User Codes
1. PERFORM the following to delete a block of Normal User Codes.
NOTE: Yellow LED will blink continuously during programming.
a. PRESS and HOLD # for approximately 5 seconds, and
RELEASE when the yellow LED blinks.
NOTE 1: After Step b, there will be green LED flash and 2 short
tones.
NOTE 2: Master Code will delete locations
3–150.
NOTE 3: Supervisor Code will delete locations 6–150.
b. ENTER Master or Supervisor Code and then #.
NOTE: After Step c, there will be green LED flash and 2 short
tones.
c. ENTER 62#.
NOTE: After Step d, there will be green LED flash and 2 short
tones.
d. ENTER first location of the block to be deleted and then #.
NOTE 1: After Step e, there will be green LED flash and 2 short
tones to indicate successful programming.
e. ENTER last location of the block to be deleted and then #.
2. PRESS # within 2 seconds to stay in programming mode.