32 80-0180-307, Rev A
CAUTION
Once loose, the battery cover is free to slide down and can fall. Be
careful to support the battery cover with free hand.
2. INSERT the included 5/64” Allen key (included) and LOOSEN the
screw to allow removal of the battery cover.
3. REPLACE the four (4) Size AA Alkaline batteries in the battery
holder ensuring proper polarity.
4. PLUG the battery pack into the eForce 150 connector (see
Figure 24).
5. INSERT the battery case into the eForce 150 (see Figure 25).
NOTE: A battery moisture shield is pre-installed at the factory to
protect the batteries from the elements.
6. SLIDE battery cover over the inserted battery case.
7. INSERT the Allen key and TURN clockwise two full turns to secure
the battery cover (see Figure 26).
Figure 24 Figure 25
Figure 26
To Next Page
Loading...
