Aerospool WT-9 Dynamic - Page 24

TECHNICAL DESCRIPTION, OPERATING, MAINTENANCE AND REPAIR MANUAL
The FLYdat has been configured for ROTAX 912 S2 engine by the manufacturer.
The following warn- and alarm limits are stored:
Display Unit Warn limit
Alarm limit
Engine speed rpm
5 800
6 000
Exhaust gas temperature EGT
o
C
880
900
Cylinder head temperature CHT
o
C
135
150
Oil temperature
o
C
130
145
Oil pressure maximum bar
6,0
8,0
Oil pressure minimum bar
2,0
1,0
Distinguish between three ranges of readings control:
Colour range Significance
Green
(standard
operation )
All readings are below or above ( min. oil pressure ) the
warn limits programmed.
Yellow
( exceeding of
warn limits )
If one or more readings exceed the programmed warn limit,
then the readings appears flashing on the display , and
simultaneously the alarm output is periodically ( 0,25 sec. )
switched on and off, until no readings exceed warn limit.
Red
( exceeding of
alarm limits )
If one or more readings exceed the programmed alarm limit,
then the readings appear flashing on the display and
simultaneously the alarm output is permanently activated
until no reading exceeds the warn limit.
If one or more alarm limits have been exceed, or the reading on the meter of the
operating hours has surpassed the programmed TBO, the maintenance message reads
as follows: „Service !“ .
CAUTION
Disregard of the warn- and alarm signals might result in injuries
or endanger the life of operator or third party.
BOMBARDIER-ROTAX as manufacturer, warrants every FLYdat for a period of not
more than 9 consecutive months for private use owners or 12 consecutive months from
date of shipment of the manufacturer or the first 150 operation hours.
Date:
01.03.2002
WT
-
9 Dynamic
Section 1 Page 1
-
17