TECHNICAL DESCRIPTION, OPERATING, MAINTENANCE AND REPAIR MANUAL
Engine starting
1. Turn the propeller by hand ( ignition switched off )
2. Open the fuel cocks
3. Set throttle lever for idle run
4. Open the choke
5. Switch on Master switch
6. Turn the key in the switch box
7. Switch on ignition switches
8. Push the starter button to start the engine
9. Adjust engine run after starting
10. Close the choke
11. Warm up the engine, check oil pressure
CAUTION
If cylinder heads and oil temperatures fall during parking among
flights than is recommended to start and warm up engine from
time to time. Do not open choke when starting hot engine.
Parking and taxiing
Check wheel brakes for freezing when parking outside and temperature is below 0°C.
Check wheels free rotation prior to taxiing ( hold a propeller and tow an aeroplane ).
Heat the brakes with hot air to remove freezing. Freezing should not be removed by
force towing.
After winter operation
• Clean the aeroplane thoroughly
• Lubricate the aeroplane per Lubricating Chart
• Check and adjust the control system
3.15 Parts with life limits
Part Lifetime Note
Airframe 3000 hours life extention inspection
Engine 1500 hours
overhaul
Propeller 1500 hours (SR200D)
800 hours (DUC)
overhaul
Rubber parts 5 years Change
Tyres 5 years Change
Brake liquid 2 years Change
Coolant liquid 2 years Change
Safety belts 12 years Change
Towing system
To Next Page
Loading...
