FILE VER LAST ISSUE LANG. PAGE
GCM02-MT-ING4 NEW.doc c/02 04/03/2003 ENG Page 40 of 57
7 Automatic test (the clock must be set)
Sets the day, weeks, time and duration of the test
Inactive
Active or inactive
Weeks 1 or 2
Days 1-7
8 Time of automatic test 8,00 From 0 to 24 Hrs
9 Duration of automatic test 10’ 0 – 60’
10 Block
To press reset. To select the day of the week. To press again
reset and to select the kind of block for that day. To press
reset and to select an other day or to press more times down
or up to exit
TOT. BLOCK
PAR. BLOCK
START
PAR.
BLOCK+START
11 Block
Sets the times at which the unit cannot start up automatically (only
manual control can be used)
12 Advertising page
To press reset. To move the cursor. To press again reset and
to select the character for the position. To press reset and to
select an other position or to press more times down or up to
exit.
13 Antitheft
It changes the alarm entry for high oil temperature (12) in
“Antitheft”, usable only with the remote control.
Temp. Oil Temp. Oil
Antitheft
14 Opening CR
It is effected the opening of the CR or by mains failure or by
start
By start
By mains failure
2.12.6. REMOTE CONTROL SETTINGS
1 Baud mains
It indicates the speed of execution of the operation effected
through the serial
9600K 9600K
19200K
38400K
57600K
2 Modbus Address
It allows to select the address modbus of the equipment
1 1-256
3 Gen-num
It allows to plan an identifier number of the group
1 1-16525
4 Modem selection
It allows to effect the choice among four different kind of
modem
Serial Serial
Falcom A2D (GSM)
Falcom TWIST (GSM)
U.S. Robotics 56K
5 Telephone number
It allows to effect the choice among different telephone
numbers previously introduced
Num. Tel. 1
Num. Tel. 2
Num. Tel. 3 SMS
Num. Tel. 4 SMS
6 PIN number
Use mode as advertising page
To Next Page
Loading...
