Afinia H800+ 3D Printer User’s Manual
30
For large surface area parts, the Fine setting will take longer to print and the corners of the raft
may lift from the platform.
UnSolid Model
Not all STL files are going to be perfect. A perfect STL file is a fully enclosed surface, with no gaps
in the surface skin, and no overlapping surfaces. If your file is not perfect, this option should allow
you to print it anyway.
The software will auto-detect models that may require this setting and check this option. You can
remove the check to de-select this function if needed.
Thin Wall (PC Only)
If your model has places where the thickness of the part is less than about 0.75mm, this option will
force the printer to include the wall when printing rather than potentially leaving it out.
This option is only available in the PC software at this time.
No Raft
You can print without a Raft, but it is not recommended. The raft improves adhesion to the
platform.
Also, the Platform Calibrate feature (see pages 15-16) is bypassed if the raft is not printed.
Heat Platform after finish
Checking this option keeps the platform temperature hot after printing is complete, which may
make it easier to remove the model from the platform. It also keeps the platform heated so you can
start your next print more quickly.
Pause At
Enter heights in millimeters to pause the printer at those heights during printing.
Multiple heights can be entered into the setting, separated by commas. Entering 13.5, 20, 27.25
will automatically pause the printing when it has reached 13.5 millimeters, 20 millimeters, and
27.25 millimeters.
This can be useful for changing filament or adding a non-printed part at a specific point during the
printing of the model.
You do not need to add the height of the raft to the numbers you enter; the software will do this for
you.
Use the printer buttons or the Maintenance window during the pause to perform the Withdraw,
Extrude, and Resume Print functions.
To Next Page
Loading...