2. SAFETY HI ROLLER - BELT CONVEYORS
2.2. INSTALLATION SAFETY HI ROLLER, MINI ROLLER, LO ROLLER & HI LIFE
10 P115506 R3
YOU are responsible for the SAFE use and maintenance of your equipment.
YOU must ensure that you and anyone else who is going to work around the
equipment understands all procedures and related SAFETY information
contained in this manual.
Remember, YOU are the key to safety. Good safety practices not only protect
you, but also the people around you. Make these practices a working part of your
safety program.
Important: Below are general instructions that apply to all safety practices. Any instructions
specific to a certain safety practice (e.g., Operational Safety), can be found in the
appropriate section. Always read the complete instructional sections and not just
these safety summaries before doing anything with the equipment.
• It is the equipment owner, operator, and maintenance personnel's responsi-
bility to read and understand ALL safety instructions, safety decals, and man-
uals and follow them when assembling, operating, or maintaining the
equipment. All accidents can be avoided.
• Equipment owners must give instructions and review the information initially
and annually with all personnel before allowing them to operate this product.
Untrained users/operators expose themselves and bystanders to possible
serious injury or death.
• Use this equipment for its intended purposes only.
• Do not modify the equipment in any way without written permission from the
manufacturer. Unauthorized modification may impair the function and/or
safety, and could affect the life of the equipment. Any unauthorized modifica-
tion of the equipment voids the warranty.
• Do not allow any unauthorized person in the work area.
2.2. INSTALLATION SAFETY
1. Splice protections / wiper cleats must be properly installed to obtain proper
reloading, to prevent product build-up on the return pan / bottom of the
trunking, and to prevent wear on the belt splice.
2. Splice protectors / wiper cleats must be properly installed on both mechanical
and vulcanized splices.
3. Never weld any item to any part of the covers, trunking, head section, or tail
section.
4. Ensure that there is proper support for the head section, tail section, and
trunking sections.
5. Clearances around the head section, tail section, and trunking are very
important for proper operation and maintenance.
6. Trunking must be installed straight and level.
CAUTION
Loaders/inlets must be installed properly to
achieve proper loading of the belt. Improper
loading can cause damage to the conveyor
components.
To Next Page
Loading...
