HI ROLLER - BELT CONVEYORS 5. INSTALLATION
HI ROLLER, MINI ROLLER, LO ROLLER & HI LIFE 5.2. HEAD END & TAIL END TRUNKING INSTALLATION
P115506 R3 39
6. Support legs, feet, and support hangers. Trunking sections must be well
supported every 20’ of the length of the conveyor.
Important: Support structures and legs must never be welded to the trunking sidewalls or
flanges. All connections must be bolted to the trunking or trunking flanges.
5.2.4. TAIL SECTION BACK COVER REMOVAL & INSTALLATION
1. The security bolt must be removed by a mechanical technician. Then, the tail
cover clamps (Figure 5.7) release the tail cover.
Figure 5.7
2. The handles on the tail cover should be used to release the tail section. The
safety chains will stop the tail cover from dropping down (Figure 5.8).
Figure 5.8
3. Lift the tail cover to release the safety chains and slowly lower the tail cover
until it releases (Figure 5.9).
To Next Page
Loading...
